HS Code:
39100000
Technical Data
Typical values, not a specification. The technical data sheet (TDS) is binding.
Product Information
- Brand
- SILISIL
- Curing type
- Non-reactive
- Container
- 1 kg, 5 kg, 25 kg
Physical Properties
- Cured Color
- Transparent
- Viscosity (cSt)
- 300 cSt
- Density (g/cm³)
- 0.970 g/cm³
Electrical Properties
- Electrical Insulation
- Yes
Product Approvals
- Food contact
- No
- Medical grade
- No
- Certificates
- RoHS, REACH
Thermal Properties
- Flash point (°C)
- >300 °C
- Pour point (°C)
- -50 °C
Product Description
SILISIL Silicone Oil 300 cSt is PDMS for higher lubrication loads and stable release films.
When selecting a silicone fluid, the specific quality, its viscosity, and the intended operating conditions are considered together. The technical data sheet and safety data sheet are part of the relevant product quality information.
300 cSt is an intermediate viscosity for applications between 200 and 500 cSt — higher load than standard lubricating oils, but still fluid enough for pump and spray application.
What distinguishes SILISIL Silicone Oil 300 cSt
What is SILISIL Silicone Oil 300 cSt used for?
Important Notes
Which viscosity for which application?
SILISIL Silicone Oil 300 cSt in direct comparison with related viscosities in our product range.
Frequently asked questions about SILISIL Silicone Oil 300 cSt
Practical application and design questions — answered by SILITECH.
SILISIL Silicone Oil 300 cSt: PDMS for higher lubrication loads and stable release films. Main applications are industrial lubrication, hydraulic damping, and long-term stable release agents.
PDMS (polydimethylsiloxane) is a linear silicone fluid that combines high thermal stability, low surface tension, very good dielectric properties, and broad temperature resistance. The viscosity (measured in centistokes, cSt) determines the field of application — low viscosities are suitable for volatile applications and lubrication, high viscosities for damping and conditioners.
SILISIL Silicone Oils are soluble in aromatic, aliphatic, and chlorinated solvents (e.g., toluene, xylene, hexane, diesel). They are not miscible with water and alcohols. For anti-foam applications, high-viscosity PDMS is diluted in hydrocarbon solvents and introduced using a dosing pump.
For storage and handling, refer to the safety data sheet for the specific product grade. Keep containers closed and observe the protective measures specified therein.
The viscosity determines the application. 300 cSt is optimal for industrial lubrication and similar application profiles. For other application characteristics, you will find related viscosities in the comparison table above — if you are unsure, we will be happy to advise you on your specific application.