Skip to content

Selecting silicone rubber: Understanding RTV, LSR and HCR

RTV-1, RTV-2, LSR and HCR overview: Select silicone rubber according to processing, mechanical function and operating conditions.

3-minute read

Material motif: silicones

Silicone rubber is a family of materials with very diverse formulations. A soft potting gel, a molding compound, and an injection-molded sealing ring can each be silicone-based, yet still require different processes and testing. Therefore, material properties, cross-linking, and component function must be considered together when selecting the right material.

Four terms for orientation

DesignationProcessingImportant selection question
RTV-1One-component, room-temperature curing siliconeCan the intended joint cross-section harden sufficiently?
RTV-2Two components are mixed before processingWhat type of crosslinking, dosage, and processing time apply to the system?
LSRPumpable liquid silicone rubber, usually processed in heated moldsDo the dosage, tools, and curing process match the quality?
HCRHighly consistent, solid silicone rubber, for example for compression molding or extrusionWhat compounding and vulcanization process are planned?

HCR denotes the high consistency of the material. Both peroxide-curing and addition-curing grades are available. LSR is offered as a two-component system; the assignment of the catalyst to A or B must be verified using the specific manufacturer's documentation.

RTV-2: Addition and Condensation

The two crosslinking methods differ in their reaction and in the handling of the components. Condensation systems can release volatile reaction products; therefore, the timing of the inspection and the conditions after demolding are relevant for dimensional accuracy. In addition-curing systems, certain contact materials can interfere with the platinum catalysis. A test with the finished master model is therefore part of the process preparation.

The mixing ratio is a property of the specific system. The designation RTV-2 or a Shore number does not imply a 1:1 ratio or a specific amount of hardener. Weight and volume ratios are only considered equivalent if the manufacturer explicitly states this.

Correctly interpreting mechanical specifications

Shore A and Shore 00 are different hardness scales. For demolding purposes, tensile strength, elongation at break, and tear resistance are also important. Tensile strength is specified, for example, in N/mm², and tear resistance in N/mm. Using the wrong unit can significantly distort product selection.

The measurement method and the age of the test specimen are part of the numerical value. The phrase "measured after 24 hours" is initially a test condition; it must not be reinterpreted as a binding time until complete cross-linking without verification.

Temperature, media and electrical function

For temperature design, duration, load, and contact media are specified. A temperature value reached only briefly is insufficient for continuous operation. Similarly, electrical insulation, electrical conductivity, and thermal conductivity are distinct functions. Fillers can improve one of these while simultaneously altering flow behavior or mechanical properties.

A seal is tested on the intended compound and medium. For electronic potting, adhesion, trapped air, moisture, and stresses from temperature fluctuations are also considered. Material testing and component testing address different questions in this context.

Physical contact and special requirements

For products intended for skin contact, documentation regarding the exact quality and intended contact conditions is required. For medical devices, this entails an assessment of the finished product, including processing and additives. For food contact, fire protection, or electrical safety requirements, appropriate documentation for the specific application must also be provided.

A sensible sampling order

A sample order describes the final part, its contact surfaces, geometry, loads, and the planned manufacturing process. During the trial, dosage, mixing time, material temperature, and time until further processing are documented. Subsequently, the finished part is tested to ensure that the required properties are achieved. This allows for a transparent evaluation of any material change.

Further basics

The current product documentation is decisive for processing.